油研電磁比例換向閥型材，進口YUKEN閥

　　上海乾拓貿易有限公司

　　企業QQ：2880626087

　　電話；021-69001039

　　手機；17321017802（微信）

　　郵箱；17321017802@163.com

　　聯系人；楊婷玉

　　地址：上海市嘉定區江橋嘉涌路99弄6號713室

　　Mounting Posture

　　For any model, there are no restrictions reg

　　mounting posture.

　　Solenoid Energisation

　　When energising one solenoid, be sure to de-energise

　　another solenoid beforehand.

　　Tank Port

　　Do not connect the tank port to any pipe line having a

　　surge pressure in it. Be sure to kenewly developed as a "Mini-series". Compared with DSG-01 series,

　　the valves are much more compactly manufactured but enjoy a maximum

　　operating pressure of 25 MPa (3630 PSI) and a maximum flow rate of

　　10 L/min (2.6 U.S.GPM), while contributing further to a space saving

　　一定要在下列規定的條件下使用液壓油：

　　粘度：20-200mm 2 / s（100-930SUU），溫度：-15?+ 60℃（5?140°F）。

　　TJ的粘度和油溫

　　必須注意保持對可能導致的液壓油污染的控制

　　故障和縮短閥門的使用壽命g we

　　包括下表中的四個內六cautious attention to a surge voltage.ep the end of the tank line

　　pipe below the oil level. As the solenoids are of wet type

　　structure, it is necessary to make piping in such condition

　　that the inside of the valve is always filled with the fluid.角頭螺栓。

　　子板可用。 從上表中子板號。 當不使用子requirement. Moreover, usin以使用下表中列出的液壓油類型。

　　安裝螺栓該

　　有一個很好的完成。arding the板時，配套表面應t armature solenoids, the valves

油研電磁比例換向閥型材，進口YUKEN閥